
Power Supply/Charger Board Only, Output 12/24VDC @ 4 Amp, Single Filtered and Electronically Regulated Output, Aux Output, FAI Fire Alarm Interface, LinQ2 Ready, Input: 120VAC, LED Visual Indicators
Part#: ALXEFLOW4NB
Hot#: 178035
Mfg: Altronix
Available: 3 ( 2 KAN, 1 LA )
Notice: The info below is not item specific.
Altronix
EFLOW4NB Power Supply Charger, Single Output, 12/24VDC @ 4A, Aux Output, FAI, LinQ2 Ready, 115VAC, Board. UL Listed Sub-Assembly power supply/charger converts 120VAC, 60Hz input into a single 12VDC or 24VDC Class 2 Rated power-limited output. It also offers a suite of Features that includes fire alarm disconnect, overvoltage protection, and low power disconnect which prevents deep discharge of stand-by batteries.
Features:
- UL Listed For:
- Access Control System Units (UL294).
- Power Supplies for use with Burglar Alarm Systems (UL603).
- Power Supplies for Fire Protective Signaling Systems (UL1481).
- cUL Listed For:
- CAN/ULC - s319-05, Electronic Access Control Systems.
- ULC-S318-96 - Power Supplies for Burglar Alarm Systems.
- Also suitable for Access Control.
- CSA Standard C22.2 No.205-M1983, Signal Equipment.
- Warranty:
- ALTRONIX® Lifetime Warranty.
- Optional Accessories:
- LINQ2: Network Supervision.
- Altronix model LINQ2 Network Communication Module provides remote supervision, control and monitoring over LAN/WAN.
- Remotely reports accurate power diagnostics.
- Controls power and resets devices.
- Reports system diagnostics via Email.
Specifications:
- Input Rating:
- Input 120VAC 60Hz, 3.5A.
- Output:
- Class 2 Rated power-limited output.
- 12VDC or 24VDC selectable output.
- 4A continuous supply current.
- Aux. Class 2 Rated power-limited output rated @ 1A (unswitched).
- Overvoltage protection.
- Filtered and electronically regulated outputs.
- Battery Backup:
- Built-in charger for sealed lead acid or gel type batteries.
- Automatic switch over to stand-by battery when AC fails. Transfer to stand-by battery power is instantaneous with no interruption.
- Fire Alarm Disconnect:
- Supervised Fire Alarm disconnect (latching or nonlatching) 10K EOL resistor. Operates on a normally open (NO) or normally closed (NC) trigger.
- Supervision:
- AC fail supervision (form „C„ contacts).
- Notification trigger is selectable for 30 seconds (factory set) or 2 hours.
- Battery fail & presence supervision (form „C„ contacts).
- Low power shutdown. Shuts down DC output terminals if battery voltage drops below 71-73% for 12V units and 70-75% for 24V units (depending on the power supply). Prevents deep battery discharge.
- Electrical:
- Temperature: Operating: 0° C to 49° C (32° F to 120° F); Storage: - 20° C to 70° C ( - 4° F to 158° F).
- Relative Humidity 85% +/- 5%
- BTU/Hr (approx.): 12VDC: 25 BTU/Hr.; 24VDC: 49 BTU/Hr.
- Visual Indicators:
- Green AC Power LED indicates 120VAC present.
- AC input and DC output LED indicators.
- Additional Features:
- Short circuit and overload protection.
- Dimensions (W x L x H):
- 4.6"(116.84mm) x 7.5"(190.5mm) x 1.75"(44.45mm).
- Weight (approximate):
- Product Weight: 0.85 Lbs. (0.39 kg).
Specifications for Altronix ALXEFLOW4NB
Other SpecsAlternate Codes | EFLOW4NB |
Category | Access Control, Alarm Power Supplies, Alarms & Intercom, Burglar Alarms, CCTV Products, Power Supplies, Wire & Power Supplies |