Command Access

The MLRK1-HAG is a practical and cost-effective way to convert a mechanical Hager 4500, IDC 8000, LSDA 9000 R/V, PDQ 6200, Stanley QED 1/2000 & Lawrence 8000 series device to an electrified latch pullback device while maintaining the UL listing. Our easy-to-install motor-driven kit installs in moments. It is equipped with PTS technology allowing for an easy post-installation adjustment of the latch/latches. Last but not least, it features an updated MM5 module with improved torque & 1 Touch PTS!

Features:

• MM5 Smart Module: On board diagnostics with audible feedback for adjustment and power issues
• “PTS”: 5 second electronic adjustment for easy post installation adjustment
• Electric dogging rated for continuous duty - auto re-engage if push pad is pulled from dogged position
• Low current draw - field switchable to “high torque” mode
• Up to 300’ wire run with 2-18ga wire - long wire runs provides installer with convenience of placing the Command locking hardware power supply in a centralized location; i.e. the same closet as the access control panel
• 6” robust Molex pigtail + 6’ power lead to easily connect to power supply lead
• Request-to-exit kit available
• 3-year “no hassle” warranty

Models:

• MLRK1-HAG: Kit for Hager 4500 series. EU 24V
• MLRK1-HAG REX: Kit for Hager 4500 series. EU 24V w/REX

Specifications:

• Voltage range: 24V +/- 10%
• System protection: unit shutdown when voltage exceeds 28VDC
• Average Current Peak: 900A
• Average Current Hold: 215mA
• PTS adjustment: approx. 1/4”