
Available: 12 ( 3 KAN, 7 PHX, 2 SEA )
Lifesafety Power Inc
The Lifesafety power Netlink module is part of Flexpower's patented power management system for security and life safety applications. NL4 is a four data port network module that communicates and controls power status over a local or wide area network. The NL4 provides four SPI ports for connection to Flexpower devices that enables monitoring and control of the power system. Typical data gathered and reported includes operational fault status, power supply output voltage, battery charging voltage, battery charging current, and fire alarm input status. Automated reports may be generated on any detected fault condition, battery aging, fire alarm interface activation, and event activation, or on a time base for scheduled confirmation of proper operation. A time and date stamped log of the past 1000 events is kept as history in a buffer and may be accessed as a scheduled report, or immediately on an alert or occurrence. The buffer is updated once per hour with all parameters in normal range. In addition to four SPI connections, the NL4 provides two current sensor inputs, a remote temperature sensor input, a volt meter input, and a contact monitor input. The current, voltage, and temperature sensors may be given upper and lower limits to trigger an alert if the measured value goes out of range. The contact monitor input may be programmed to respond to either a normally open or normally closed contact or voltage presence or loss. Two outputs are also provided for use in power cycling external equipment with RB relay modules or interfacing to the C4, C8, or M8 modules.
Features:
- System integrity / battery health / output condition
- 1000 Event buffer
- Monitor health and status of host power supply, battery set, and up to twenty four individual outputs (requires M8 module)
- Auto-schedule, test, and report battery standby time
- Remote supervision of battery's state of charge
- Monitoring internal cabinet temperature
- Monitoring external room temperature with over temp alert
- Remote power cycling control of external equipment
- Time/date stamp log reports last 1000 events
Specifications:
- Input Operating Voltage: 8 to 30 VDC
- Input Operating Current: 60 mA nomina
- Network Data Rate: 10/100 Mbps
- Voltage Measurement Range: 0 to 30 VDC ±3% (10-30V)
- Current Measurement Range: 0 to 20A ±0.1A +5% of reading
- Event Input: 8 to 30 VDC
- Output 1, 2 Max Sink Current: 50 mA
Specifications for Lifesafety Power Inc LSINL4-BOXED
Other SpecsAlternate Codes | NL4-BOXED, NL4BOXED |
Category | Access Control, Alarm Power Supplies, Alarms & Intercom, Burglar Alarms, CCTV Products, Power Supplies, Wire & Power Supplies |