Altronix AL300ULM Multi-Output Power Supply/Charger

AL300ULM multi-output access control power supply/charger is specifically designedfor use with access control systems and accessories. This unit converts a 115VAC / 60Hz input into five (5) individually protected Class 2 Rated power limited 12VDC or 24VDC outputs.

Each output will route power to a variety of access control hardware devices including Mag Locks, Electric Strikes, Magnetic Door Holders, etc. These outputs will operate in both Fail-Safe and Fail-Secure modes.

Controlled trigger input is achieved through normally open (N.O.) or normally closed (N.C.) supervised input or the polarity reversal from an FACP (Fire Alarm Control Panel). A form "C" dry output relay enables HVAC Shutdown, Elevator Recall or may be used to trigger auxiliary devices.

SPECIFICATIONS

• Input:
• Input 115VAC / 60Hz, 3.5 amp.
• Input fuse rated @ 3.5 amp/250V.
• Fire Alarm Panel or Access Control System trigger inputs. N.O. or N.C. supervised trigger input and polarity reversal trigger input.
• Output:
• 12VDC or 24VDC selectable outputs.
• 2.5 amp supply current.
• Burglar Alarm Applications:
• 12VDC = 10VDC-13.2VDC
• 24VDC = 20VDC-26.4VDC
• Five (5) PTC protected outputs, rated @ 2 amp.
• Output relay energizes when unit is triggered (form "C" contact rated 1 amp @ 28VDC).
• Filtered and electronically regulated output.
• Short circuit and thermal overload protection.
• Battery Backup:
• Built-in charger for sealed lead acid or gel type batteries.
• Automatic switch over to stand-by battery when AC fails.
• Maximum charge current 0.7 amp.
• Supervision:
• AC fail supervision (form "C" contacts).
• Notification trigger is selectable for 30 seconds (factory set) or 6 hours.
• Low battery supervision (form "C" contacts).
• Battery presence supervision (form "C" contacts).
• Power fail supervision relay (form "C" contacts).
• Visual Indicators:
• AC input and DC output LED indicators (power supply board).
• Red LEDs indicate condition of power outputs (multi-output board).
• Power and input trigger LEDs (multi-output board).
• Electrical:
• Operating temperature: 0° C to 49° C ambient.
• BTU/Hr.:
• 12VDC: 15.35 BTU/Hr.
• 24VDC: 30.71 BTU/Hr.
• System AC input VA requirement: 402.5VA.
• Mechanical:
• Enclosure Dimensions (H x W x D approx.): 13.5" x 13" x 3.25" (342.9mm x 330.2mm x 82.55mm)
• Accommodates up to two (2) 12VDC/7AH batteries.
• Product weight (approx.): 7.6 lbs. (3.45 kg).
• Shipping weight (approx.): 8.6 lbs. (3.9 kg).